Skip to content
Shield Gate Repair

Westlake · Tarrant County

All-O-Matic Gate Repair in Westlake, TX

All-O-Matic operators in Westlake run heavy estate gates on ranch acreage and commercial slides near SH 114. They are simple and well supported, so repair is usually the answer.

  • Licensed & Insured
  • 16+ Years Experience
  • Open 24/7
  • Residential & Commercial

What we see on All-O-Matic gates in Westlake

An All-O-Matic suits the heavy estate gates on Westlake’s ranch acreage and the commercial slides near the campuses. On estate swings, heavy leaves and long drives mean the SW-350 torque limiter slips if hinges stiffen, and limit cams drift over thousands of cycles. On commercial slides, an SL-150 or SL-175DC PRO runs many cycles, so chains stretch, sprockets wear and board relays fail. In each case the operator is usually reporting a fault elsewhere, not failing itself.

We check the gate by hand, then repair the worn hinge, chain, sprocket, limit or relay. Those parts remain easy to order because the brand is still made. On commercial entrances that tie into card systems or staffed security near Davis Boulevard, we test the interface with the access control too. On estate gates, we check that the operator is sized for the gate’s weight. Most visits keep the original operator in service.

On video

Gate repairs near Westlake on video

Filmed on our own jobs nearby, each marked with its city: Southlake (7 mi), Coppell (13 mi), Fort Worth (17 mi).

What usually fails on All-O-Matic operators

  • Limit nut or cam slip and travel drift
  • Clutch or torque-limiter slip causing stalls (SL-150, SW-300, SW-350)
  • Electronic reversing device sensitivity set wrong for the gate
  • Chain stretch and sprocket wear
  • Control board relay failure

All-O-Matic gate repair across Dallas–Fort Worth →

All-O-Matic models we repair in Westlake

Areas we cover in Westlake

  • Vaquero
  • Glenwyck Farms
  • Terra Bella
  • Granada
  • Paigebrooke
  • Entrada

More of our All-O-Matic work

Recent All-O-Matic work by our technicians across Dallas–Fort Worth.

  • An All-O-Matic sliding gate operator on a raised steel pad, driving a cedar-panel sliding gate
  • An All-O-Matic slide gate operator against a dark painted board fence, with the drive chain running along the gate
  • An All-O-Matic operator on a steel stand with its drive chain attached to a wooden sliding gate

Customer testimonials

What our customers say

Customers across Dallas–Fort Worth, filmed at their own gates, All-O-Matic owners and Westlake customers first. We bring the same team to Westlake.

All-O-Matic gate repair in Westlake: questions

Our All-O-Matic estate gate in Westlake stalls and reverses. What is it?

Usually the torque limiter or reversing device responding to a gate that has become hard to move, often from stiff hinges on a heavy leaf. We check the gate by hand, fix the hinges, then reset the limiter and limits. Turning the force up without fixing the gate would just wear the gearbox.

Can an All-O-Matic work with a campus access control system?

Yes. All-O-Matic operators accept open commands from card readers, keypads and security systems wired to the board. When an entrance stops responding, we test both the operator and the access control so the fault is found on one visit rather than through two separate call-outs to different contractors.

Gate Not Working Right Now?

We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives. See what counts as a gate emergency.

Call NowText UsEstimate