Skip to content
Available 24/7 Emergency Gate Repair Service
Shield Gate Repair

Flower Mound · Denton County

Swing Gate Repair in Flower Mound, TX

Swing gate repair in Flower Mound for long-drive entrance gates, ranch and acreage gates, and paddock gates. We correct posts, hinges and sag first, then adjust the operator to suit.

  • Licensed & Insured
  • 16+ Years Experience
  • Open 24/7
  • Residential & Commercial
Call (214) 735-4314Get a Free Estimate

Swing Gate Repair in Flower Mound: what we see

Swing gates do most of the work in Flower Mound. The Cross Timbers district’s two-acre lots favor long-drive swing gates at the road, and equestrian properties often have additional ranch and paddock swing gates further in. Long single leaves carry a lot of weight on their hinges, and clay soil moves the posts. Over time the leaf drops, the latch misses, and the limits drift so the operator stops short or overshoots. Paddock and farm gates suffer most, because their posts were often set lighter than an entrance gate’s.

Our swing gate repair in Flower Mound starts with the hang of the leaf. With the operator released, we check how far the leaf has dropped, how the hinges have worn and whether the post has leaned. We correct the post and hinges rather than fitting a stronger operator to pull against them. Then we check the operator arm, brackets, battery or power, and reset limits and force. Gates in Bridlewood or on acreage off FM 2499 Long Prairie Rd get the same sequence.

Real jobs nearby

Our nearest documented jobs to Flower Mound

Work our technicians have documented, each shown under the city it was in.

All case studies

On video

Gate jobs near Flower Mound on video

Filmed on our own jobs, each marked with its city: Southlake (7 mi), University Park (21 mi), Richardson (21 mi).

Signs you need swing gate repair

  • Gate sags, or the latch no longer lines upWorn hinges, a post that has moved, or a gate frame that has racked out of square
  • Gate drags on the drivewayA leaning post or hinge wear — the operator is now fighting the ground on every cycle
  • Arm moves but the gate barely doesA bent or worn operator arm, a loose or broken bracket, or a stripped drive
  • One leaf of a double gate lags or will not closeAn arm or board fault on that side, or the two leaves have drifted out of sync
  • Gate will not hold closed, or swings in the windA missing gate stop or latch, or an operator left in manual release
  • Hums at the start of travel and stallsA failing capacitor, or a gate that has become too heavy to start moving

Swing Gate Repair across Dallas–Fort Worth →

Our recent swing gate repair work

Photos from our technicians' recent jobs across Dallas–Fort Worth.

  • Ornate wrought iron double swing gates between stone-clad pillars, both leaves open with an operator at each post
  • A black iron swing gate with scroll detailing and an operator arm, opening onto a driveway beside a brick house
  • A white ornamental iron swing gate with spear finials and a linear operator arm
  • A black iron swing gate with a diagonal-bar pattern, its operator arm and open control box on a brick pillar
  • Double ornamental iron swing gates between stone pillars, with the operator box at the base
  • A black iron swing gate with patriotic bunting on the fence and its arm operator at the hinge

Customer testimonials

What our customers say

Customers across Dallas–Fort Worth, filmed at their own gates. We bring the same team to Flower Mound.

Watch every customer video

Areas we cover in Flower Mound

  • Bridlewood
  • Wellington of Flower Mound
  • Canyon Falls
  • The Estates at Tour 18
  • Chateau du Lac
  • The Preserve at Flower Mound
  • Wichita Creek Estates

Swing Gate Repair in Flower Mound: questions

Our paddock gate in Flower Mound drags on the ground. Can it be fixed?

Usually. A dragging paddock gate is normally a post that has moved in the clay or hinges that have worn under the leaf’s weight. We reset or reinforce the post, adjust or replace hinges, and add a support wheel where it suits the gate. If it is automated, we reset the operator after the gate hangs true.

Should a long swing gate have a stronger operator?

Only if the operator is genuinely undersized for the leaf. More often, a gate that seems too heavy is binding on worn hinges or a moved post. We check the gate first and size the operator against the leaf length and weight. Fitting a bigger operator to a binding gate just moves the damage elsewhere.

More gate services in Flower Mound

Gate opener brands we repair in Flower Mound

Gate Not Working Right Now?

We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives. See what counts as a gate emergency.

(214) 735-4314Request a callback
Call NowText UsEstimate