Lake Worth · Tarrant County
Viking Gate Repair in Lake Worth, TX
Viking gate operator repair in Lake Worth for heavy commercial and yard gates along the Jacksboro Highway and I-820. We check rollers and alignment before the operator.
- Licensed & Insured
- 16+ Years Experience
- Open 24/7
- Residential & Commercial
What we see on Viking gates in Lake Worth
Viking builds operators for heavy gates and high cycles, and in Lake Worth those are the cantilever and slide gates on storage, auto and yard lots along SH 199. A busy business gate wears its cantilever rollers, and worn rollers make the gate drag, which loads the gearbox and drive chain on the Viking. That is why failures on these units so often trace back to the gate. Viking operators are DC with batteries, so a weak battery slows a heavy gate further, and an older K-2 slide operator can lose its limits after a total power failure.
For a Lake Worth Viking, we disconnect the operator and move the gate by hand. Worn cantilever rollers, bent tracks or misalignment get fixed first. Then we test the battery, reset limits, inspect the gearbox and chain and check loop detectors. On older residential gates near Lakeside Drive, corroded hinges in damp air are the more likely cause of a struggling R-6 swing.
Real jobs nearby
Our nearest documented Viking jobs to Lake Worth
Viking work our technicians have documented in nearby cities, each shown under the city it was in.
On video
Viking jobs near Lake Worth on video
Filmed on our own jobs nearby, each marked with its city: Richardson (43 mi).
What usually fails on Viking operators
- Control board and logic faults
- Limit switch drift on swing operators such as the T-21 and R-6
- Lost limits on older K-2 slide operators after a total power failure
- Battery and solar charging failures
- Gearbox and drive chain wear on heavy gates
- Loop detector faults
Viking models we repair in Lake Worth
Areas we cover in Lake Worth
- Indian Oaks
- Lakeview Heights
- Crestridge
- Lakeside Drive near the shoreline
- Charbonneau Road area
More of our recent gate repair work
Recent gate operator jobs by our technicians across Dallas–Fort Worth.
Customer testimonials
What our customers say
Customers across Dallas–Fort Worth, filmed at their own gates. We bring the same team to Lake Worth.
Viking gate repair in Lake Worth: questions
Our Lake Worth yard gate with a Viking operator drags. Is the operator failing?
Usually not. On a busy commercial cantilever gate, worn rollers are the common cause, and the drag makes the Viking strain and wear its gearbox. We replace the rollers, realign the gate and then check the battery, limits and drive. Fixing the gate first stops the operator wearing out early and costs far less.
Does a Viking K-2 lose its settings in a Lake Worth power cut?
Older K-2 slide operators can lose their limits after a total power failure, for example if the battery has run flat. We reset the limits and test the battery so it carries the gate through future outages. On a business lot, a battery that cannot last through a short cut should be replaced before it causes downtime.
Every gate service in Lake Worth
Not a Viking? We repair every major operator brand in Lake Worth, plus sliding, swing, commercial and access control work.
- Gate repair in Lake Worth
- LiftMaster gate repair in Lake Worth
- Elite gate repair in Lake Worth
- All-O-Matic gate repair in Lake Worth
Viking gate repair near Lake Worth
Other cities where we have documented Viking jobs.
Gate Not Working Right Now?
We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives. See what counts as a gate emergency.