Southlake · Tarrant County
Gate Motor Repair in Southlake, TX
Gate motor repair in Southlake for the drive side of an operator: motor, start capacitor, gearbox, brake and thermal cutout. Heavy iron gates load a motor hard, so we also find out why it failed.
- Licensed & Insured
- 16+ Years Experience
- Open 24/7
- Residential & Commercial
Gate Motor Repair in Southlake: what we see
Motors in Southlake gate operators carry heavy work. A tall wrought iron swing leaf or a wide estate slide gate needs a lot of torque, and the operators fitted during the 1990s build-out have been delivering it for decades. The usual motor-side failures follow from that. A weak start capacitor leaves an AC motor humming without turning. Gearbox wear shows up as grinding or a gate that coasts past its stop. A thermal cutout that trips on summer afternoons usually means the gate is binding, not that the motor is finished.
We release the operator and check the gate runs freely, because a binding hinge or flat roller will kill a new motor as fast as the old one. Then we test the capacitor, measure motor current, inspect the gearbox and brake, and check the cutout. Capacitors and brakes are routine replacements; motor or gearbox replacement depends on parts support for that model. For homes in Carillon or Clariden Ranch, we set out the repair and replacement options side by side before work starts.
Real jobs nearby
Our nearest documented jobs to Southlake
Work our technicians have documented, each shown under the city it was in.
US AutomaticFort Worth, TXresidentialAnother Company Said Replace It. We Refurbished It Instead.
A Fort Worth homeowner had been told the solar operator needed replacing. The board was corroded, the arm needed repair and the gate was leaning — all fixable.
Read the case study
LiftMasterUniversity Park, TXresidentialA Gate Left Unused for a Year, a Broken Bracket and a Broken Arm
The customer had not operated the gate in about twelve months and wanted it working again. The bracket and the operator arm had both failed.
Read the case study
LiftMasterRichardson, TXresidentialThe Board Had Physically Fallen Inside the Operator
A Sunday call from a senior customer. The circuit board had come loose and failed, and because it had stopped charging them, both backup batteries had gone too.
Read the case study
On video
Gate jobs near Southlake on video
Filmed on our own jobs, each marked with its city: Fort Worth (17 mi), University Park (21 mi), Richardson (23 mi).
Signs you need gate motor repair
- Motor hums, gate does not moveSeized gearbox, failed capacitor, or the gate is binding on its track
- Clicks once, then nothingDead capacitor or a control board relay
- Opens partway then stops or reversesLimit switch out of adjustment, or a safety sensor seeing an obstruction
- Keypad works, remote does notReceiver or remote programming — often the cheapest fix on this list
- Beeps and will not respondBattery backup fault or a board error code
- Works fine, then dies in the heatThermal cutout — usually a failing motor under load, worth catching early
Our recent gate motor repair work
Photos from our technicians' recent jobs across Dallas–Fort Worth.
Customer testimonials
What our customers say
Customers across Dallas–Fort Worth, filmed at their own gates. We bring the same team to Southlake.
Areas we cover in Southlake
- Timarron
- Carillon
- Kirkwood Hollow
- Shady Oaks
- Coventry Manor
- Clariden Ranch
Gate Motor Repair in Southlake: questions
Our gate motor hums but the gate does not move. Is the motor dead?
Not necessarily. On an AC operator, a hum without movement is very often a failed start capacitor, which is a small part to replace. It can also be a seized gearbox or a gate that is jammed. We check the gate by hand, test the capacitor, and measure the motor before deciding anything needs replacing.
Why does the gate motor cut out in the Southlake summer heat?
Most operators have a thermal cutout that stops the motor before it overheats. On a hot day, a motor that is also fighting a heavy, dragging gate reaches that limit sooner. Once it cools it runs again. The fix is usually the gate, its hinges, rollers or post, rather than the motor itself, and we check both.
More gate services in Southlake
- Gate repair in Southlake
- Automatic Gate Repair in Southlake
- Electric Gate Repair in Southlake
- Driveway Gate Repair in Southlake
- Sliding Gate Repair in Southlake
- Swing Gate Repair in Southlake
- Gate Opener Repair in Southlake
- Emergency Gate Repair in Southlake
- Commercial Gate Repair in Southlake
- Residential Gate Repair in Southlake
- Automatic Gate Installation in Southlake
- Electric Gate Installation in Southlake
- Sliding Gate Installation in Southlake
- Swing Gate Installation in Southlake
- Gate Opener Installation in Southlake
Gate opener brands we repair in Southlake
Gate Not Working Right Now?
We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives. See what counts as a gate emergency.