Skip to content
Shield Gate Repair

Highland Park · Dallas County

Viking Gate Repair in Highland Park, TX

Viking gate repair in Highland Park for the DC swing and slide operators carrying heavy decorative iron. We check the battery, the hinges and the posts before we decide anything about the operator itself.

  • Licensed & Insured
  • 16+ Years Experience
  • Open 24/7
  • Residential & Commercial

What we see on Viking gates in Highland Park

A Viking is usually chosen because the gate is heavy, and Highland Park ironwork often is: tall wrought iron leaves, sometimes original to a house built when the town was laid out between 1907 and 1924. Viking swing units such as the T-21 and R-6 set travel with mechanical limit switches, and when a post in Highland Park clay leans a little, the leaf no longer stops where the limit expects. The result is a gate that bumps its stop, reverses, or leaves a gap at the latch.

Most of what we find on a Viking here is repairable: a tired battery, a limit that needs resetting once the post is plumb again, worn pivots under the iron, or a board hit by a storm. We would replace a Viking only for real gearbox wear or a board that is no longer supported. On narrow drives off Armstrong Parkway or in Old Highland Park, we also realign the photo eyes, since a short drive leaves little margin.

On video

Viking jobs near Highland Park on video

Filmed on our own jobs nearby, each marked with its city: Richardson (9 mi).

What usually fails on Viking operators

  • Control board and logic faults
  • Limit switch drift on swing operators such as the T-21 and R-6
  • Lost limits on older K-2 slide operators after a total power failure
  • Battery and solar charging failures
  • Gearbox and drive chain wear on heavy gates
  • Loop detector faults

Viking gate repair across Dallas–Fort Worth →

Viking models we repair in Highland Park

Areas we cover in Highland Park

  • Old Highland Park
  • Lakeside
  • Highland Park West
  • Turtle Creek Acreage
  • Hackberry Creek Acreage

More of our recent gate repair work

Recent gate operator jobs by our technicians across Dallas–Fort Worth.

  • A cedar-panel sliding gate on a steel frame, with its slide operator at the end of the track
  • A black steel sliding gate across a wooded driveway, with the operator beside the post
  • A black steel sliding gate running along a brick house, with its operator and toolkit at the end of the track
  • A technician kneeling at the operator of a tall dark wood-clad sliding gate
  • A sliding gate operator mounted behind a stained wood gate on a concrete driveway
  • A white aluminium sliding gate with its operator control box fixed to the post

Customer testimonials

What our customers say

Customers across Dallas–Fort Worth, filmed at their own gates. We bring the same team to Highland Park.

Viking gate repair in Highland Park: questions

Why does my Viking swing gate in Highland Park stop short of closing in late summer?

Dry months shrink the clay around the hinge post, and a heavy iron leaf pulls the post slightly out of plumb. The leaf then meets its latch at a different point than the mechanical limit was set for. We reset the post or hinge first, then adjust the Viking limits, so the fix holds once the ground moves back.

Does a Viking need a battery even with mains power at the gate?

Most Viking installs run DC with a battery so the gate still works in a power cut. That battery is a consumable and wears out in Texas heat even when mains charging is fine. A Viking that has turned sluggish or stops partway is often asking for a new battery, which we load test before touching anything else.

Gate Not Working Right Now?

We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives. See what counts as a gate emergency.

Call NowText UsEstimate