Skip to content
Shield Gate Repair

Hickory Creek · Denton County

All-O-Matic Gate Repair in Hickory Creek, TX

All-O-Matic gate repair in Hickory Creek for the rugged pad-mounted operators on retrofitted lake drives. These units are simple, and simple operators are repaired, not replaced.

  • Licensed & Insured
  • 16+ Years Experience
  • Open 24/7
  • Residential & Commercial

What we see on All-O-Matic gates in Hickory Creek

An All-O-Matic retrofitted to a Hickory Creek drive faces conditions it was not designed around. Driveways from the cabin era are short, steep and often gravel, so slide gates collect grit in the track and rollers, and swing leaves on a slope put uneven load on the arm. On an SL-100 or SL-150, a dragging gate makes the clutch slip and the chain stretch. On an SW-300, the torque limiter slips when a leaf fights the slope. Summer lake traffic then adds cycles, and limit nuts and cams drift sooner.

Repair means fixing the gate so it runs freely, then setting the operator. We clean the track, check the rollers, adjust the clutch or torque limiter, reset limits and replace worn chains and sprockets. The electronic reversing device often needs adjusting after the gate is freed up. On drives in Shadow Creek Estates or off Point Vista Road, we also check whether the operator position suits the slope.

On video

Gate repairs near Hickory Creek on video

Filmed on our own jobs nearby, each marked with its city: Coppell (12 mi), Frisco (13 mi), Southlake (14 mi).

What usually fails on All-O-Matic operators

  • Limit nut or cam slip and travel drift
  • Clutch or torque-limiter slip causing stalls (SL-150, SW-300, SW-350)
  • Electronic reversing device sensitivity set wrong for the gate
  • Chain stretch and sprocket wear
  • Control board relay failure

All-O-Matic gate repair across Dallas–Fort Worth →

All-O-Matic models we repair in Hickory Creek

Areas we cover in Hickory Creek

  • Shore Haven
  • Steeplechase
  • Shadow Creek Estates
  • The Enclave of Hickory Creek
  • Harbor Grove Estates

More of our All-O-Matic work

Recent All-O-Matic work by our technicians across Dallas–Fort Worth.

  • An All-O-Matic sliding gate operator on a raised steel pad, driving a cedar-panel sliding gate
  • An All-O-Matic slide gate operator against a dark painted board fence, with the drive chain running along the gate
  • An All-O-Matic operator on a steel stand with its drive chain attached to a wooden sliding gate

Customer testimonials

What our customers say

Customers across Dallas–Fort Worth, filmed at their own gates, All-O-Matic owners and Hickory Creek customers first. We bring the same team to Hickory Creek.

All-O-Matic gate repair in Hickory Creek: questions

My All-O-Matic swing gate in Hickory Creek stalls halfway up the drive. Why?

A swing leaf fighting a steep drive puts extra load on the arm, and the torque limiter or clutch slips to protect the operator. We check the hinges and hang, adjust the torque limiter and reset the limits. On very steep drives, a slide gate may be a better long-term answer.

Does gravel damage an All-O-Matic slide operator in Hickory Creek?

Gravel does not usually damage the operator directly, but grit in the track and rollers makes the gate drag. That causes clutch slip, chain stretch and reversing. We clean the track, check the rollers and chain, and suggest a paved strip or guard to keep gravel out.

Every gate service in Hickory Creek

Not a All-O-Matic? We repair every major operator brand in Hickory Creek, plus sliding, swing, commercial and access control work.

All-O-Matic gate repair near Hickory Creek

    Gate Not Working Right Now?

    We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives. See what counts as a gate emergency.

    Call NowText UsEstimate