Skip to content
Shield Gate Repair

Frisco · Collin County

Electric Gate Repair in Frisco, TX

Electric gate repair in Frisco for gates that are dead, tripping or running erratically. We trace the power path and the loops from supply to board, so the right part is replaced the first time.

  • Licensed & Insured
  • 16+ Years Experience
  • Open 24/7
  • Residential & Commercial

Electric Gate Repair in Frisco: what we see

Frisco gates are mostly modern DC operators with battery backup, many with access control on the same supply, and some running on solar. That shifts electrical faults toward charging, loop detectors and low-voltage wiring rather than old motors. Collin County spring storms add surge damage to boards and detectors, and new construction nearby can nick a buried cable or a loop wire long after the gate went in.

We test the incoming supply and transformer, battery voltage under load, charger or solar output and fuses, then the board and each loop detector and loop. Damaged splices are remade in sealed connectors and cut loops are recut. On access controlled gates we check the reader and controller supply as well. Electric gate repair in Frisco follows the same order in Frisco Lakes or at an entrance off the Sam Rayburn Tollway.

On video

Gate jobs near Frisco on video

Filmed on our own jobs, each marked with its city: Prosper (6 mi), Richardson (15 mi), Coppell (17 mi).

Signs you need electric gate repair

  • No power to the gate at allBreaker, transformer, or damaged supply run
  • Intermittent operationLoose connection, corroded terminal, or a failing board
  • Works after rain, fails when dry (or vice versa)Moisture ingress or a damaged buried cable
  • Tripping the breakerShort in the operator, wiring or an accessory — stop using the gate
  • Solar gate dying after a few cyclesBattery at end of life or a charging fault, not the operator
  • Burning smell from the housingKill power immediately and call

Electric Gate Repair across Dallas–Fort Worth →

Our recent electric gate repair work

Photos from our technicians' recent jobs across Dallas–Fort Worth.

  • An old gate operator opened up with two removed circuit boards laid on the grass during a board replacement
  • An ageing sliding gate operator stripped down to its frame and control board in the corner of a wood gate
  • An operator control box opened beside a wood fence, with tools laid out on the ground
  • A swing gate operator and its open control panel during an electrical repair
  • A swing gate arm operator and its control box mounted on a brick wall
  • A gate operator removed for repair beside a wood gate, with tools and parts cases on the driveway

Customer testimonials

What our customers say

Customers across Dallas–Fort Worth, filmed at their own gates. We bring the same team to Frisco.

Areas we cover in Frisco

  • Starwood
  • Newman Village
  • Phillips Creek Ranch
  • Stonebriar
  • Frisco Lakes
  • Panther Creek

Electric Gate Repair in Frisco: questions

Construction work near our Frisco gate started causing faults. Could that be connected?

Quite possibly. Trenching, landscaping and paving close to a gate can cut or nick buried power cables and loop wires, and the symptoms can be intermittent at first. We test each circuit and loop for continuity and insulation, locate the damage, and repair or replace the affected section.

Is surge protection worth adding to a gate?

On gates that have already taken a surge, usually yes. A surge suppressor on the power supply and on loop and access wiring costs little next to a control board, and Collin County storms are a regular source of damage. We can fit it during the repair so the new board is protected.

Gate Not Working Right Now?

We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives. See what counts as a gate emergency.

Call NowText UsEstimate