Grapevine · Tarrant County
FAAC Gate Repair in Grapevine, TX
FAAC gate repair in Grapevine for hydraulic swing arms and in-ground operators on older homes and lakeside properties. We service the hydraulics on site rather than writing them off as unrepairable.
- Licensed & Insured
- 16+ Years Experience
- Open 24/7
- Residential & Commercial
What we see on FAAC gates in Grapevine
A FAAC moves the gate with hydraulic pressure: a motor runs a pump, and fluid pushes the ram. Grapevine’s older housing stock means some of these units have been in service a long time, and that age shows up as worn seals, lost fluid and pressure that no longer finishes the stroke. Near Grapevine Lake moisture is the other factor. An in-ground unit such as the 750 or 770 sits in a box under the hinge, and if that box does not drain, water reaches the operator and its connections.
The sequence is fluid level and condition, then pressure against FAAC’s figures, then seals and the release valve, which on the hydraulic units is a keyed bypass and a genuine wear item. The 455 D board used with the hydraulic swing operators is a known failure point on older installs and is replaceable once confirmed. A 400 or 402 arm is rarely too old to service. Replacement is for physical damage to the housing or ram. We repair FAAC gates in Heritage Oaks, Original Town and off SH 26 Ira E. Woods Ave.
Real jobs nearby
Our nearest documented jobs to Grapevine
Gate operator work our technicians have documented in nearby cities, each shown under the city it was in.
Video
Southlake, TXresidentialThe Control Box Had Been Left Open. Debris and Corrosion Did the Rest.
An open enclosure let debris collect around the electronics and moisture reach the board. The board and the backup batteries were replaced; the opener stayed.
Read the case study Video
EagleCoppell, TXresidentialThe Operator Was 26 Years Old. It Is Still Working.
An Eagle 2000 that is no longer manufactured, on a gate with worn wheels and a stretched chain. Replacing the worn parts cost a fraction of replacing the unit.
Read the case study Video
LiftMasterUniversity Park, TXresidentialA Gate Left Unused for a Year, a Broken Bracket and a Broken Arm
The customer had not operated the gate in about twelve months and wanted it working again. The bracket and the operator arm had both failed.
Read the case study
On video
Gate repairs near Grapevine on video
Filmed on our own jobs nearby, each marked with its city: Southlake (3 mi), Coppell (4 mi), University Park (18 mi).
What usually fails on FAAC operators
- Hydraulic fluid loss and seal failure
- Pump pressure drop causing slow or partial travel
- Control board faults, including the 455 D board on hydraulic swing units
- Encoder and limit adjustment drift
- Release-key valve leaks
- Cold-weather viscosity slowdown
FAAC models we repair in Grapevine
Areas we cover in Grapevine
- Historic Grapevine Township
- College Street Historic District
- Original Town
- Dove Creek
- Silver Lake
- Heritage Oaks
More of our recent gate repair work
Recent gate operator jobs by our technicians across Dallas–Fort Worth.
Customer testimonials
What our customers say
Customers across Dallas–Fort Worth, filmed at their own gates. We bring the same team to Grapevine.
FAAC gate repair in Grapevine: questions
Our in-ground FAAC near Grapevine Lake keeps having problems. Is the location the cause?
It may well be. An in-ground operator sits in a foundation box below the hinge, and where the ground holds water the box can flood if its drain is blocked or was never connected. Water damages the operator and corrodes the connections over time. We clear and test the drain, check for water ingress, and service the operator itself while we are there.
Why is my FAAC gate slow some mornings?
Hydraulic fluid thickens when it is cold, so a FAAC can run noticeably slower on a cold morning and normally by afternoon. That is expected behavior. If it is slow in mild weather too, low fluid from a seal leak or a pressure fault is the likelier cause, and both of those are repairs we carry out on site.
Every gate service in Grapevine
Not a FAAC? We repair every major operator brand in Grapevine, plus sliding, swing, commercial and access control work.
- Gate repair in Grapevine
- LiftMaster gate repair in Grapevine
- DoorKing gate repair in Grapevine
- All-O-Matic gate repair in Grapevine
- Elite gate repair in Grapevine
- Viking gate repair in Grapevine
- US Automatic gate repair in Grapevine
- Apollo gate repair in Grapevine
- Ramset gate repair in Grapevine
- Automatic Gate Repair in Grapevine
- Electric Gate Repair in Grapevine
- Driveway Gate Repair in Grapevine
- Sliding Gate Repair in Grapevine
- Swing Gate Repair in Grapevine
- Gate Opener Repair in Grapevine
- Gate Motor Repair in Grapevine
- Emergency Gate Repair in Grapevine
- Commercial Gate Repair in Grapevine
- Residential Gate Repair in Grapevine
- Automatic Gate Installation in Grapevine
- Electric Gate Installation in Grapevine
- Sliding Gate Installation in Grapevine
- Swing Gate Installation in Grapevine
- Gate Opener Installation in Grapevine
FAAC gate repair near Grapevine
Gate Not Working Right Now?
We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives. See what counts as a gate emergency.









