LiftMaster Gate Repair in Aurora, TX

Aurora is a small commuter town of custom homes, and lots in places like Aurora Vista run roughly one to two acres with the house well back from the road. Many have a dual-leaf ornamental iron gate on a LiftMaster LA412UL or similar dual swing. Over time the two leaves drift out of sync and stop meeting in the middle, usually because one limit has crept or one hinge has worn. Safety sensors trip for no obvious reason. On acreage with septic and irrigation, a cut loop or control wire can look exactly like a failed board until someone traces it.

We start with the gate: check both hinges and posts, then reset the limits so the leaves meet properly. Photo-eyes and safety edges get cleaned, aligned and tested. If the operator is erratic, we trace the wiring between the gate, the operator and any loop before suspecting the board, especially after recent digging. Keypads and remotes that died after a power surge are usually a receiver or keypad replacement. Off FM 718 or along the SH 114 corridor, most of these jobs finish in one visit.