Skip to content
Shield Gate Repair

Argyle · Denton County

Viking Gate Repair in Argyle, TX

Viking gate repair in Argyle for DC swing and slide operators on wide entrance gates far from the house. We test the solar and battery side first, because on acreage that is where Vikings usually falter.

  • Licensed & Insured
  • 16+ Years Experience
  • Open 24/7
  • Residential & Commercial

What we see on Viking gates in Argyle

Vikings are built for heavy gates, and Argyle produces plenty: ranch entrance swing gates and wide estate slides sized so a horse trailer can pass. Those gates often sit hundreds of feet from the meter, so the Viking runs on DC with a battery charged by solar. When a panel ends up under a tree that has grown, or a battery wears out in the heat, the gate slows and stalls in a way that looks just like a failing motor.

On an Argyle Viking we load test the battery, measure the panel and charge controller, then check the gate. A wide leaf on a post set in moving ground puts huge load on a T-21 or G-5 drive train. Older K-2 slide units without the position sensor can also forget their limits after the battery goes flat overnight, which is fixed by relearning them. We see these faults on properties off FM 407 and Crawford Road, and in Old Argyle.

On video

Viking jobs near Argyle on video

Filmed on our own jobs nearby, each marked with its city: Richardson (28 mi).

What usually fails on Viking operators

  • Control board and logic faults
  • Limit switch drift on swing operators such as the T-21 and R-6
  • Lost limits on older K-2 slide operators after a total power failure
  • Battery and solar charging failures
  • Gearbox and drive chain wear on heavy gates
  • Loop detector faults

Viking gate repair across Dallas–Fort Worth →

Viking models we repair in Argyle

Areas we cover in Argyle

  • Canyon Falls
  • Harvest
  • Country Lakes
  • Waterstone Estates
  • Old Argyle

More of our recent gate repair work

Recent gate operator jobs by our technicians across Dallas–Fort Worth.

  • A cedar-panel sliding gate on a steel frame, with its slide operator at the end of the track
  • A black steel sliding gate across a wooded driveway, with the operator beside the post
  • A black steel sliding gate running along a brick house, with its operator and toolkit at the end of the track
  • A technician kneeling at the operator of a tall dark wood-clad sliding gate
  • A sliding gate operator mounted behind a stained wood gate on a concrete driveway
  • A white aluminium sliding gate with its operator control box fixed to the post

Customer testimonials

What our customers say

Customers across Dallas–Fort Worth, filmed at their own gates. We bring the same team to Argyle.

Viking gate repair in Argyle: questions

Our Viking slide gate in Argyle lost its open and close positions. Why?

Older K-2 units without Viking’s position sensor can lose their limits after a total loss of power, and on a solar gate a flat battery counts. We relearn the limits on site, then find out why the battery ran down, whether shade on the panel, a failed charge controller or simply more cycles than the system was sized for.

Is a Viking worth repairing on a wide farm entrance?

Usually. Batteries, boards, limit hardware and charge controllers are all replaceable, and the Viking itself is built for this kind of gate. The bigger question is often the gate: a sagging leaf or a leaning post makes any operator labor, so we fix the hinge or post first, then tune the Viking.

Gate Not Working Right Now?

We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives. See what counts as a gate emergency.

Call NowText UsEstimate