Viking Gate Repair in Richland Hills, TX

A Viking on a Richland Hills yard is often moving a long, heavy gate across rough ground, and many run DC with battery storage. That combination shows up in two ways. The gate develops drag from dirty rollers, a sinking wheel or a bent section, and the Viking’s drive train pushes against it every cycle, wearing the gearbox and chain. Meanwhile the battery is asked for more current than it was budgeted for, so it ages faster. The owner sees a gate that slows through the day, which looks like a dying motor.

We check the gate by hand first, then load-test the battery and confirm the charge. On swing models such as the T-21 or G-5, mechanical limits drift and adjust in place. On an older K-2 slide without the position sensor, limits may need re-learning after a total power loss. Loop detectors in yards with heavy plant take damage and are a frequent cause of gates that will not close. Boards and batteries are generally available, and gearbox parts are usually a short order.