Hurst · Tarrant County
Viking Gate Repair in Hurst, TX
Viking gate repair in Hurst usually means a heavy commercial gate in a busy yard. Impact damage and loop faults cause more calls than the operator itself, so we check those first.
- Licensed & Insured
- 16+ Years Experience
- Open 24/7
- Residential & Commercial
What we see on Viking gates in Hurst
Viking operators are specified for heavy, high-cycle gates, which is why they turn up on the larger service yards around Hurst’s retail district. Two things keep sending them back for repair. One is impact: a truck that clips a heavy leaf bends it slightly, and the Viking’s drive train then pushes against that bind every cycle, wearing the gearbox and chain. The other is detection. Loop detectors in busy yards get damaged by heavy vehicles and pavement repairs, and a faulty loop either holds the gate open or will not open it at all.
Our sequence: move the gate by hand, test the battery on DC units, read the loop values, then look at the board. Swing operators such as the R-6 or E-4 have mechanical limits that drift after a strike and adjust in place. Older K-2 slides without the position sensor may need limits re-learned after a power failure. Gearbox and chain parts are typically a short order, and boards and batteries are generally available. In yards off Precinct Line Road, keeping the operator clear of turning trucks prevents repeat damage.
Real jobs nearby
Our nearest documented Viking jobs to Hurst
Viking work our technicians have documented in nearby cities, each shown under the city it was in.
On video
Viking jobs near Hurst on video
Filmed on our own jobs nearby, each marked with its city: Richardson (27 mi).
What usually fails on Viking operators
- Control board and logic faults
- Limit switch drift on swing operators such as the T-21 and R-6
- Lost limits on older K-2 slide operators after a total power failure
- Battery and solar charging failures
- Gearbox and drive chain wear on heavy gates
- Loop detector faults
Viking models we repair in Hurst
Areas we cover in Hurst
- Hurst Hills
- Bellaire Place
- Billy Creek Estates
- Walker Oaks
- Simpson Park
More of our recent gate repair work
Recent gate operator jobs by our technicians across Dallas–Fort Worth.
Customer testimonials
What our customers say
Customers across Dallas–Fort Worth, filmed at their own gates. We bring the same team to Hurst.
Viking gate repair in Hurst: questions
Our Viking gate in Hurst stays open all the time. Is the operator broken?
Usually not. A gate that will not close is often getting a constant open signal from a damaged loop or a detector set too sensitive, which is common in yards where heavy trucks cross the loop all day. A blocked or misaligned photo-eye can also hold it open. We test the loop and sensors first. If they are clean, we look at the Viking board and limits.
Is a Viking worth repairing after repeated truck strikes?
Yes, as long as the housing and gearbox are sound. Viking operators are built for heavy work, and the parts that suffer in a strike, such as limits, chains and arms, are replaceable. What matters more is stopping the strikes: straightening the gate, protecting the operator or relocating it. Otherwise any operator, new or repaired, will keep failing.
Every gate service in Hurst
Not a Viking? We repair every major operator brand in Hurst, plus sliding, swing, commercial and access control work.
- Gate repair in Hurst
- LiftMaster gate repair in Hurst
- DoorKing gate repair in Hurst
- All-O-Matic gate repair in Hurst
Viking gate repair near Hurst
- Viking in Euless
- Viking in North Richland Hills
- Viking in Richland Hills
- Viking in Colleyville
- Viking in Haltom City
Other cities where we have documented Viking jobs.
Gate Not Working Right Now?
We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives. See what counts as a gate emergency.