Skip to content
Shield Gate Repair

Colleyville · Tarrant County

Electric Gate Repair in Colleyville, TX

Electric gate repair in Colleyville for gates that are dead, intermittent or tripping. On wide lots the power path is long, and we trace it from the breaker to the operator before replacing anything.

  • Licensed & Insured
  • 16+ Years Experience
  • Open 24/7
  • Residential & Commercial

Electric Gate Repair in Colleyville: what we see

Large Colleyville lots often put the gate well away from the house, which means a long low-voltage or mains run buried in clay. Clay that swells and shrinks works on conduit joints and splices, and moisture finds the weak point. Add older AC operators with tired capacitors, and spring storms that send surges through boards and loop detectors, and electrical faults here have several likely sources.

We begin at the breaker and the incoming supply, then the transformer or power supply, fuses, and the voltage reaching the operator under load. After that come the board, the loop detector and the loop itself, which can crack where a driveway has moved. Splices are remade in sealed connectors. Whether the run comes off Precinct Line Road or through a back lot in Woodland Hills, we test each section rather than guessing.

On video

Gate jobs near Colleyville on video

Filmed on our own jobs, each marked with its city: Southlake (4 mi), Coppell (10 mi), Fort Worth (14 mi).

Signs you need electric gate repair

  • No power to the gate at allBreaker, transformer, or damaged supply run
  • Intermittent operationLoose connection, corroded terminal, or a failing board
  • Works after rain, fails when dry (or vice versa)Moisture ingress or a damaged buried cable
  • Tripping the breakerShort in the operator, wiring or an accessory — stop using the gate
  • Solar gate dying after a few cyclesBattery at end of life or a charging fault, not the operator
  • Burning smell from the housingKill power immediately and call

Electric Gate Repair across Dallas–Fort Worth →

Our recent electric gate repair work

Photos from our technicians' recent jobs across Dallas–Fort Worth.

  • An old gate operator opened up with two removed circuit boards laid on the grass during a board replacement
  • An ageing sliding gate operator stripped down to its frame and control board in the corner of a wood gate
  • An operator control box opened beside a wood fence, with tools laid out on the ground
  • A swing gate operator and its open control panel during an electrical repair
  • A swing gate arm operator and its control box mounted on a brick wall
  • A gate operator removed for repair beside a wood gate, with tools and parts cases on the driveway

Customer testimonials

What our customers say

Customers across Dallas–Fort Worth, filmed at their own gates. We bring the same team to Colleyville.

Areas we cover in Colleyville

  • Saddlebrook
  • Highland Meadows
  • Covington
  • Whittier Heights
  • Brook Meadows
  • Woodland Hills

Electric Gate Repair in Colleyville: questions

Our Colleyville gate died after a thunderstorm. What usually needs replacing?

Often a single component took the surge: the control board, a fuse, the transformer or the loop detector. We test each one before ordering anything, because replacing the whole operator for one damaged board is a common and expensive mistake. Where storms are a recurring problem, we can talk about surge protection on the supply and the loop.

The gate works some days and not others. Is that electrical?

Intermittent operation is very often a loose or corroded connection, a failing transformer, or a splice that lets in water after rain. On a long buried run the fault can sit anywhere along it. We check voltage at each point under load and note the conditions when it fails, which usually narrows it down quickly.

Gate Not Working Right Now?

We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives. See what counts as a gate emergency.

Call NowText UsEstimate