Skip to content
Shield Gate Repair

Keller · Tarrant County

Electric Gate Repair in Keller, TX

Electric gate repair in Keller for the power side of a gate: supply, transformer, low-voltage wiring, boards and loop detectors. A dead or erratic gate gets traced from the outlet to the operator.

  • Licensed & Insured
  • 16+ Years Experience
  • Open 24/7
  • Residential & Commercial

Electric Gate Repair in Keller: what we see

Electric faults in Keller fall into two groups. On private drives, buried low-voltage runs laid with the house get nicked by irrigation and landscaping work as yards mature, and splices that were never sealed corrode. At the gated village entrances, the electrical problem is often under the road: loops cut or crushed when an entrance is resurfaced, which makes a gate open on its own or ignore a waiting car.

We start at the supply and work out. Voltage at the outlet or breaker, the transformer output, the low-voltage run with a continuity test, then the board, receiver and loop detector. A North Texas storm can take out several of those at once, so each one is tested on its own and you pay only for what failed. Where surge protection was left out on entrances along Bear Creek Pkwy or in Hidden Lakes, we can add it to the supply and loop leads.

On video

Gate jobs near Keller on video

Filmed on our own jobs, each marked with its city: Southlake (5 mi), Coppell (12 mi), Fort Worth (14 mi).

Signs you need electric gate repair

  • No power to the gate at allBreaker, transformer, or damaged supply run
  • Intermittent operationLoose connection, corroded terminal, or a failing board
  • Works after rain, fails when dry (or vice versa)Moisture ingress or a damaged buried cable
  • Tripping the breakerShort in the operator, wiring or an accessory — stop using the gate
  • Solar gate dying after a few cyclesBattery at end of life or a charging fault, not the operator
  • Burning smell from the housingKill power immediately and call

Electric Gate Repair across Dallas–Fort Worth →

Our recent electric gate repair work

Photos from our technicians' recent jobs across Dallas–Fort Worth.

  • An old gate operator opened up with two removed circuit boards laid on the grass during a board replacement
  • An ageing sliding gate operator stripped down to its frame and control board in the corner of a wood gate
  • An operator control box opened beside a wood fence, with tools laid out on the ground
  • A swing gate operator and its open control panel during an electrical repair
  • A swing gate arm operator and its control box mounted on a brick wall
  • A gate operator removed for repair beside a wood gate, with tools and parts cases on the driveway

Customer testimonials

What our customers say

Customers across Dallas–Fort Worth, filmed at their own gates. We bring the same team to Keller.

Areas we cover in Keller

  • Hidden Lakes
  • Marshall Ridge
  • Bourland Oaks
  • Harmonson Farms
  • Saddlebrook Estates
  • Highland Oaks

Electric Gate Repair in Keller: questions

Our Keller entrance was repaved and now the gate opens by itself. Electrical fault?

Very likely the vehicle loop. It is a wire buried in the road surface, and paving, milling or trenching can break it or damage its lead-in. A broken loop can read as a car constantly present, or never present. We test the loop and detector, and if the loop is damaged, a new one is cut into the surface.

What does a surge protector on a gate actually protect?

It sits on the power supply and, ideally, the loop and keypad leads, and diverts a voltage spike before it reaches the control board. It will not save a gate from a direct strike, but it reduces damage from nearby lightning and grid surges, which is the common storm call. It is a small addition during any electrical repair.

Gate Not Working Right Now?

We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives. See what counts as a gate emergency.

Call NowText UsEstimate