Electric Gate Repair in University Park, TX

Rebuilding is constant in University Park, and every rebuild disturbs the ground around a gate. Trenching for new utilities, irrigation and hardscape is how buried gate wiring gets nicked or cut, and on a tight lot the cable often runs right under the work. On new installs the wiring is fresh but sometimes rushed: splices left unsealed, a transformer sharing a circuit it should not, a vehicle loop cut too close to a slide gate track. On older properties the cable has simply aged in clay that wets and dries every season.

We start at the supply and work outward: incoming power and breaker, transformer output, board input, then each low-voltage run, loop and sensor lead in turn, with continuity and insulation tested rather than assumed. Thunderstorm surges can take out a board, a receiver and a loop detector together, so we test each one separately and add surge protection where it was left out. We work on electric gates across the 75205 and 75225 zip codes, including Caruth Hills and University Heights.