Electric Gate Installation in University Park, TX

Electrical work for a gate on a University Park lot usually means getting power across a short but crowded strip of ground. Between the house and the gate there may be new irrigation, hardscape, utility lines and a driveway, and on rebuilt properties all of it may have been dug recently. That is exactly where buried gate cable gets damaged later if it was not run in conduit at a sensible depth. Clay that wets and dries every season is also hard on unsealed splices, and a splice that fails underground is slow and disruptive to find.

We plan the route before trenching: a dedicated circuit where needed, a transformer sized and placed for the operator, conduit for every low-voltage run, sealed splices and a clear record of where cables sit. Vehicle loops are cut and sealed where future work will not cross them, and surge protection is fitted on the supply and on the loop and keypad leads. Safety devices are wired and tested to UL 325. We confirm what the city and your HOA require for electrical work near the street.