University Park · Dallas County
Gate Motor Repair in University Park, TX
Gate motor repair in University Park for operators that hum, overheat, stall or will not start. We test the motor, capacitor, gearbox and thermal cutout separately, so you only replace the part that failed.
- Licensed & Insured
- 16+ Years Experience
- Open 24/7
- Residential & Commercial
Gate Motor Repair in University Park: what we see
Motors on University Park gates fail in two ways. On older operators around Volk Estates the motor and gearbox have simply run for a long time, and bearings, gears and capacitors wear. On newer installs the motor is often fine but overworked: an operator chosen for a lighter leaf than the heavy iron it ended up carrying, or a gate that has settled and binds, makes the motor draw more current, run hotter and trip its thermal cutout. That second case is a gate or sizing problem showing up as a motor problem.
Our sequence is to move the gate by hand to rule out mechanical drag, then check the capacitor on AC motors, the motor current and windings, the thermal cutout and the gearbox for wear or stripped teeth. A failed capacitor is a quick fix, a worn gearbox can sometimes be rebuilt, and a burnt motor on an old operator is where replacing the operator may make more sense. We repair gate motors off Preston Road, Lovers Lane and in Caruth Hills.
Real jobs nearby
Our nearest documented jobs to University Park
Work our technicians have documented, each shown under the city it was in.
LiftMasterRichardson, TXresidentialThe Board Had Physically Fallen Inside the Operator
A Sunday call from a senior customer. The circuit board had come loose and failed, and because it had stopped charging them, both backup batteries had gone too.
Read the case study
Southlake, TXresidentialThe Control Box Had Been Left Open. Debris and Corrosion Did the Rest.
An open enclosure let debris collect around the electronics and moisture reach the board. The board and the backup batteries were replaced; the opener stayed.
Read the case study
US AutomaticProsper, TXresidentialWe Tested the Bent Arm Before Replacing It
A gate that had not worked in a long time. The battery was flat, and the visibly bent arm was tested on the chance it could be kept.
Read the case study
On video
Gate jobs near University Park on video
Filmed on our own jobs, each marked with its city: Richardson (7 mi), Southlake (21 mi), Prosper (26 mi).
Signs you need gate motor repair
- Motor hums, gate does not moveSeized gearbox, failed capacitor, or the gate is binding on its track
- Clicks once, then nothingDead capacitor or a control board relay
- Opens partway then stops or reversesLimit switch out of adjustment, or a safety sensor seeing an obstruction
- Keypad works, remote does notReceiver or remote programming — often the cheapest fix on this list
- Beeps and will not respondBattery backup fault or a board error code
- Works fine, then dies in the heatThermal cutout — usually a failing motor under load, worth catching early
Our recent gate motor repair work
Photos from our technicians' recent jobs across Dallas–Fort Worth.
Customer testimonials
What our customers say
Customers across Dallas–Fort Worth, filmed at their own gates. We bring the same team to University Park.
Areas we cover in University Park
- Volk Estates
- Caruth Hills
- Windsor Place
- Stratford Manor
- University Heights
Gate Motor Repair in University Park: questions
My gate motor hums but the gate does not move. What failed?
A humming motor that will not turn is very often a failed start capacitor on an AC operator, or a gearbox whose teeth have stripped so the motor spins without driving the gate. It can also be a gate jammed so hard the motor cannot start it. We release the gate, check it by hand, then test the capacitor and gearbox in turn.
Why does my gate motor quit after a few cycles in a row?
That is the thermal cutout doing its job. When a motor runs hot, from a binding gate, an undersized operator or heavy use, it shuts down until it cools. Replacing the cutout or the motor does not solve it. We find out what is loading the motor, correct that, and then confirm the motor current is back where it should be.
More gate services in University Park
- Gate repair in University Park
- Automatic Gate Repair in University Park
- Electric Gate Repair in University Park
- Driveway Gate Repair in University Park
- Sliding Gate Repair in University Park
- Swing Gate Repair in University Park
- Gate Opener Repair in University Park
- Emergency Gate Repair in University Park
- Commercial Gate Repair in University Park
- Residential Gate Repair in University Park
- Automatic Gate Installation in University Park
- Electric Gate Installation in University Park
- Sliding Gate Installation in University Park
- Swing Gate Installation in University Park
- Gate Opener Installation in University Park
Gate opener brands we repair in University Park
- Elite gate repair in University Park
- Eagle gate repair in University Park
- DoorKing gate repair in University Park
- Viking gate repair in University Park
- FAAC gate repair in University Park
- US Automatic gate repair in University Park
- Apollo gate repair in University Park
- Ramset gate repair in University Park
- LiftMaster gate repair in University Park
Gate Not Working Right Now?
We answer the phone 24/7. If you are stuck, call and we will talk you through the manual release before anyone arrives. See what counts as a gate emergency.